Red-lion BMK7A User Manual download pdf

INSTALLATION

BMK6 - Open Base Mount

Before attaching the BMK6 to the panel or frame, it is recommended to wire and mount the unit to

ensure good electrical connections. The following steps outline the most common sequence for installing

a unit without an MLPS attached.

1. Install the grommet (provided in the accessory bag) in the hole in the base mount.

2. Assemble nut fastener and mounting screw onto both sides of the mounting clip. The

tip of the screw should not project from the hole in mounting clip.

3. Slide the panel gasket over the rear of the unit to the back of the bezel.

Then install the unit through the opening in the front of the base mount

until the bezel flange makes contact.

4. Slide the mounting clip over the rear of the unit until the

mounting clip is against the inside of the base mount. The

mounting clip has latching features which engage into

mating features on the unit’s housing.

Note: It is necessary to hold the unit in place when sliding the

mounting clip into position.

5. Alternately tighten each screw to ensure uniform gasket

compression.

6. Connect the necessary wires from the grommet to the unit.

7. Mount the base mount enclosure to the panel or frame as application

requires. Four bolts and nuts are provided with the Base Mount Kit.

DESCRIPTION

The BMK6, BMK7 and BMK7A base mounts are designed for use with the

CUB4, CUB5, and DT8 units. The BMK7 is large enough to accommodate a

Micro-line Power Supply (MLPS) attached to a CUB4 or DT8. The BMK7A

will accommodate a Micro-line Power Supply (MLPS) attached to a CUB5.

The wires can either be brought through the panel on which the unit is

mounted, or through the hole(s) in the enclosure itself. Grommets are provided

to insert in the hole(s) on the base mount (where applicable) when wires are

routed through it. The grommets are in the accessory bag with each base mount

unit, along with four nuts and bolts for mounting.

The base mounts are constructed of steel with a textured black finish.

MODEL BMK6, BMK7 & BMK7A - BASE MOUNT KIT FOR CUB4, CUB5 & DT8 UNITS

BMK7/BMK7A - CLOSED BASE MOUNT KIT

(With or Without MLPS)

BMK6 - OPEN BASE MOUNT KIT

(Without MLPS)

DIMENSIONS In inches (mm)

Bulletin No. BMK6/7-E

Drawing No. LP0392

Released 6/08

Tel +1 (717) 767-6511

Fax +1 (717) 764-0839

www.redlion.net

A B C

3.45

(87.63)

2.80

(71.12)

4.00

(101.50)

3.50

(88.90)

MODEL

BMK7

BMK7A

4.00

(101.50)

4.62

(117.35)

1 2

Summary of Contents

Page 1 - DIMENSIONS In inches (mm)

INSTALLATIONBMK6 - Open Base MountBefore attaching the BMK6 to the panel or frame, it is recommended to wire and mount the unit toensure good electric

Page 2 - ORDERING INFORMATION

INSTALLATIONBMK7/BMK7A - Closed Base MountBefore attaching the BMK7/BMK7A to the panel or frame, it isrecommended to wire and mount the unit to ensure