Red-lion TSC User Manual download pdf (Page 55)

Display Parameter

Range and Units

(Factory Setting

Value)

Description/

Comments

CYC2 Cooling output

cycle time

0 to 120 sec

(2)

0 turns OP2 off.

GAN2 Relative cooling

gain

0.0 to 10.0

(1.0)

0.0 places cooling

output into ON/OFF

control mode and

db-2 becomes

hysteresis value,

db-2 Heating/cooling

overlap-deadband

-999 to 9999

(0)

Positive value is

deadband.

Negative value is

overlap. If GAN2 =

0, this parameter is

cooling ON/OFF

control hysteresis.

-53-

QUICK REFERENCE TABLE: CONFIGURATION COOLING MODULE 5 (5-O2)

Unit returns to configuration access point if cooling option not installed.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 91 92

THE TEMPERATURE SETPOINT 1
CONTROLLER 1
US LISTED 2
Table of Contents 3
GENERAL DESCRIPTION 8
SAFETY SUMMARY 9
INSTALLATION ENVIRONMENT 9
STANDARD UNIT INSTALLATION 9
UNIT REMOVAL PROCEDURE 11
REMOVING BEZEL ASSEMBLY 11
INSTALLING BEZEL ASSEMBLY 11
OUTPUT MODULES 12
SELECT INPUT SENSOR TYPE 13
WIRING CONNECTIONS 14
SELECT AC POWER (115/230 VAC) 14
EMC INSTALLATION GUIDELINES 14
FRONT PANEL DESCRIPTION 16
OPERATION OVERVIEW 17
PROFILE OPERATING MODES 18
CONTROLLING A PROFILE 20
CONFIGURATION OF PARAMETERS 24
PARAMETER ENTRY 25
NORMAL DISPLAY MODE 25
Profile Status Description 26
UNPROTECTED PARAMETER MODE 27
PROTECTED PARAMETER MODE 28
FRONT PANEL PROGRAM DISABLE 29
HIDDEN FUNCTION MODE 30
INPUT MODULE (1- IN) 31
INPUT MODULE (1- IN) (Cont’d) 32
OUTPUT MODULE (2-OP) 34
OP - Percent output power 35
SP - Process setpoint value 35
LOCKOUTS MODULE (3-LC) 36
(OPTIONAL) 41
CONTROL POINTS MODULE (7-CP) 44
PROFILES MODULE (8-PR) 44
(correction shift) 51
Yes/no (no) 56
COMMUNICATION FORMAT 60
SENDING COMMANDS AND DATA 60
RECEIVING DATA 62
SERIAL CONNECTIONS 64
PID CONTROL 66
INTEGRAL TIME (Cont’d) 67
DERIVATIVE TIME 67
PID ADJUSTMENTS 67
PROCESS RESPONSE EXTREMES 68
ON/OFF CONTROL 69
AUTO-TUNE 71
AUTO-TUNE (Cont’d) 72
DIMENSIONS In inches (mm) 74
“....” or “-...” IN DISPLAY 78
OUTPUT LEAKAGE CURRENT 81
APPENDIX “D” - MANUAL TUNING 82
CLOSED LOOP CYCLING METHOD 83
APPENDIX “E” - CALIBRATION 84
CALIBRATION 85
OP Output Power 87
SPLO Setpoint Lower Limit 87
Configure Control Points 88
Configure Profiles 88
Controller Operating Mode 88
LIMITED WARRANTY 91
TSC/IM - B 5/05 92
DRAWING NO. LP0275 92

Comments to this Manuals

No comments

Red-lion TSC User Manual Page 55

Comments to this Manuals

Related products and manuals for Hardware Red-lion TSC